August 31

Plaque Assay for Phage Discovery

Print Friendly, PDF & Email

Date: August 29, 2018

Title: Plaque Assay for Phage Isolation

Rationale: Regardless of spot test result, a plaque assay is done to obtain another measure of phage presence.

Materials: Arthrobacter, LB Broth, 2X Top Agar, 1M CaCl2, Enriched lysate, pipet, micropipette, plate, vials

Procedure: To create an aseptic zone, the following was done:

  • Counter washed and wiped with CiDecon
  • Counter sprayed with 70% EtOH and allowed to evaporate completely (to dehydrate and kill any bacteria on the counter and avoid contamination)
  • Ethanol lamp lit to create rising heat and a current that protests samples from falling contamina

 

  • mL Arthrobacter and 10 microliters of filtered enriched lysate (filtered at spot test)

In 50 mL tube the following was added (for 3 plaque assays and 1 group control):

  • 8 mL LB
  • 10 mL 2X Top Agar
  • 90 microliters CaCl2

~18 mL of solution

  • Once the solution was finished, 4.5 mL was added to the small vial of Arthrobacter + lysate (enriched, filtered) and poured onto the plate. (NOTE: One vial was broken in the transition to the plate. The counter was re-sanitized, and another vial was prepared)

Results/Observations: The plate and the solution were yellowish and was put into the incubator to grow over the weekend. If the result is positive, I would expect to see growth on the plaque assay, and a negative result on the control. A negative result would constitute contamination on the control, or no growth on the plaque assay. Assuming a positive result, the next step would be to begin isolating the discovered phage. (See attached picture of resulting plaque assay plate before incubation)

Plaque Assay (Pre-incubation)


Posted August 31, 2018 by cooper_johnson1 in category Cooper Johnson

Leave a Comment

Your email address will not be published. Required fields are marked *

*