November 30

11/26/18 Webbing Plates

Print Friendly, PDF & Email

11/26/18 Webbing Plates

Objective:

The goal of this procedure is to assist Lucy P. in getting a large amount of high titer lysate. This is achieved by webbing and then flooding plates. This procedure will detail the process of webbing enough plates to have enough high titer lysate to proceed with more testing.

The overarching question this test seeks to address is: Is the presence of phage determined by species of oak tree from which soil was collected?

In other words, are specific oak tree species more likely to have Arthrobacter bacteria phages in the soil surrounding them?

The question specific to my lab table is: Is the difference in the presence of phage between live oaks and red oaks on Baylor’s campus?

As a group, we hope to expand our question to include more species as we gather data so that we can better address our overarching question and we will look at our metadata to examine whether or not there are other factors that may determine phage presence.

Procedures and Protocols:

Materials for an Aseptic zone:

  • CiDecon
  • 70% Ethanol
  • Ethanol Burner

Materials for a Plaque Assay:

  • .5 ml Arthrobacter
  • incubator
  • Pipette
  • Test tube stand
  • 50 ml tubes
  • Culture tube
  • LB Broth
  • 2X TA
  • 1M Calcium Chloride
  • Agar plate
  • Serological pipette

In order to complete the procedure, an aseptic zone was created.

  1. CiDecon was applied to the lab table with a squeeze bottle and wiped away with a paper towel
  2. 70% Ethanol was also applied with a squeeze bottle, spread with a paper towel, and allow to evaporate
  3. An ethanol burner was light in order to use the rising heat from the flame to form the aseptic zone

Then plaque assays to web plates were performed.

  1. Seven agar plates were labeled
  2. 10 µL of lysate 1 at 10^-3 dilution were transferred into each of the four culture tube containing .5 ml of Arthrobacter
  3. The culture tubes were set aside for 15 minutes.

While the lysate and bacteria are allowed to sit in the culture tube the agar was prepared.

  1. The agar was prepared according to the following recipe (makes 7 plates):
  2. 4.5 ml of the agar was transferred to the plate labeled “TA control”
  3. The plate was swirled and set aside
  4. 4.5 ml of the agar was transferred into each culture tube
  5. The resulting mixture was poured into the corresponding plates
  6. The was set aside for 10 minutes to allow agar to solidify.
  7. Plates were left to incubate until nest class
Results:

The results of this procedure will not be immediately clear but everything appeared to go according to plan.

Update: These plates essentially lysed making perfect plates to flood (see image below).

Analysis:

The idea behind the procedures as a whole is to enable us to create larger quantities of high titer lysate. In theory, this can be done after a plaque has been purified by creating webbed plates that can be flooded with phage buffer. The resulting mixture then holds many phage, and the titer can be tested with a plaque assay or spot test. This procedure yielded perfect plates to flood so the resulting lysate should be high titer and there should be a lot of it.

Future:

During our next lab period, we will flood these webbed plates.


Posted November 30, 2018 by Lucy in category Uncategorized

About the Author

Hi, my name is Lucy Fisher and I'm a freshman in Baylor's BEARS in the SEA program.

Leave a Comment

Your email address will not be published. Required fields are marked *

*